Anodic TiO 2 film on Ti substrate was fabricated at 180V in sulfuric acid solutions containing phosphoric acid and hydrogen peroxide. Effects of the anodizing conditions on the morphology of the oxide layers, and chemical states of the component elements of the layers were studied primarily using SEM, XRD, AFM, and XPS. The pores in the oxide layer was not uniform in size, shape, and growth direction particularly near the interface between the substrate and the oxide layer, compared with those of the surface layer. The formation of irregular type of pores seemed to be attributed to spark discharge phenomena which heavily occurred during increasing the anodic voltage. The pore diameter and the cell size increased, and the number of cells per unit area decreased with the increasing time. From the XPS results, it was shown that component elements of the electrolytes, P and S, existed in the chemical states of PO ?3 4 , P 2 O 5 , SO ?2 4 , SO ?2 3 , P, S, etc., which were penetrated from the electrolytes into the oxide layer during anodization.