In this study, different membranes were prepared using conventional polymer (high impact polystyrene) and polyaniline to evaluate their use in electrodialysis. Two different preparation modes were tested: chemical mixture with subsequent solvent evaporation; and mechanical mixture with subsequent pressing under heating. The purpose was to understand the effect of production methods on membrane microstructure and ionic transport. Membranes were characterized by swelling study, Fourier transformed infrared spectroscopic, scanning electron microscopy, thermogravimetric analysis and dynamic mechanical analysis. Ionic transport through the membranes was evaluated using a three-compartment cell. The results of the produced membranes were compared with those of the commercial Nafion 450 membrane. (C) 2009 Elsevier B.V. All rights reserved.