A case study was carried out to investigate the bed agglomeration observed in a fluidized bed incinerator when burning blends of three wastes (carbon soot, biosludge and fuel oil). Several instrumental approaches were employed (i.e. XRF, SEM, XRD, and ICP-AES) to identify the bed materials (fresh sand and degrader sand) and clinkers formed in the full-scale incinerator tests. Several elements (V, Al, S, Na, Fe, Ni, P, and CI), which normally are associated with the formation of low melting point compounds, were found in the waste blends at high content levels. The clinker bridges were identified to be associated with Al, Fe, V, K, Na, S, Ni, and Si elements. The effects of temperature and blending ratio were investigated in a muffle furnace. Carbon soot is believed to be more susceptible to the clinker formation than the other two fuels. Thermodynamic multi-phase multi-component equilibrium calculations predict that the main low melting point species could be Al-2(SO4)(3), Fe-2(SO4)(3), Na2SO4, NaCl, Na2SiO3 and V2O5. This information is useful to understand the chemistry of clinker formation. Also, it helps to develop methods for the control and possible elimination of the agglomeration problem for the design fuels. (C) 2002 Elsevier Science Ltd. All rights reserved.