Water removal from the gas diffusion layer (GDL) is crucial for the efficient operation of proton exchange membrane (PEM) fuel cell. Static pressure gradient caused by the fast reactant flow in the flow channel is one of the main mechanisms of water removal from GDL Reactant can leak or cross directly to the neighboring channel via the porous GDL in the cells with serpentine flow channel and many of its modifications. Such cross flow plays an important role for the removal of liquid water accumulated in the GDL especially under land area. To investigate the characteristics of liquid water behavior in the GDL under pressure gradient, the fibrous porous structure of the carbon paper is modeled by three dimensional impermeable cylinders randomly distributed in the in-plane directions and unsteady two-phase simulations are conducted. It is shown that the permeability from the numerical model matches well the experimental measurements of the common GDLs in the literature. The contact angle and pressure gradient are the key parameters that determine the initiation and the process of liquid water transport in the GDL which is initially wet with stagnant liquid water. It has been observed that the larger contact angle results in faster water removal from the GDL. Numerical simulations are performed for a wide range of pressure gradient with different contact angles to determine the minimum pressure gradient that initiates the liquid water transport in the GDL. It is found that the amount of pressure gradient caused by the cross flow is sufficient and effective to get rid of the liquid water accumulated in the GDL. The simulation results are also compared with experimental data in literature showing a good agreement. The characteristics of liquid water discharging from the gas diffusion layer are also described. (C) 2009 Elsevier Ltd. All rights reserved.