A new and growing family of polyethylene (PE)-based pressure pipes have a polypropylene (PP) skin. The effect of the PP skin on the structure and properties of the core PE pipe was investigated by comparing the skinned pipe with an uncoated pipe made from the same PE material and with the same dimensions. The annealing effect introduced by the skin changed the PE core pipe density profile across the wall thickness, increasing density in the PE core pipe near to its outer surface. The density at the bore of the coated and the uncoated pipe was similar. The melting temperature and enthalpy of melting data from DSC agreed with the density profile results. The melting temperature of PE core pipe material close to the PP skin increased with increasing skin thickness. Residual stress assessment indicated that, as the PP skin thickness increased, the PE core pipe had a lower level of overall residual stress in the hoop direction. Long-term hydrostatic strength (LTHS) tests were carried out and showed a higher strength for the coated pipe than the uncoated one. The observed structural changes have been used to explain the relative strength of these two PE pipes. POLYM. ENG. SCI., 2012. (C) 2011 Society of Plastics Engineers