The nucleated isotactic polypropylene (iPP) was molded by water-assisted injection molding. The crystalline morphology and orientation distribution were studied. The results show that shear brought by melt filling and pressurized water penetration can separately induce the formation of oriented structures in skin region (i.e., the region near mold cavity wall) and the water channel region. For virgin iPP, slightly oriented lamellae appear exclusively in the above aforementioned regions. However, shish-kebab structure occurs not only in skin and water channel region of the iPP containing moderate content of nucleator (0.2 wt%) but also in the whole region of the iPP containing a higher content of nucleator (1 wt%). It is well known that nucleator cannot directly induce the development of shish-kebab in the absence of shear, thus the results indicate: shear flow actually distributes over a much broader range than expected; in shear field, nucleator is significantly helpful for the shear which is not sufficient to solely induce oriented structure to promote the formation of the oriented structure. POLYM. ENG. SCI., 52:725-732, 2012. (C) 2012 Society of Plastics Engineers