We have investigated the self-assembling properties of the class I hydrophobin Vmh2 isolated from the fungus Pleurotus ostreatus. Five different hydrophobin self assembled samples including monolayers, bilayers, and rodlets have been prepared by Langmuir technique and studied at the nanoscale. Local wettability and visco-elasticity of the different hydrophobins samples were obtained from atomic force spectroscopy experiments in dynamic mode performed at different, controlled relative humidity (RH) values. It was found that hydrophobins assembled either in rodlets or in bilayer films, display similar hydropathicity and viscoelasticity in contrast to the case of monolayers, whose hydropathicity and viscoelasticity depend on the adopted preparation method (Langmuir-Blodgett or Langmui-Schaeffer). The comparison with monolayers properties evidences a rearrangement of the bilayers adsorbed onto solid substrates. It is shown that this rearrangement leads to the formation of a stable hydrophobic film, and that the rodlets structure consists in fragments of restructured proteins bilayers. Our results support the hypothesis that the observed variations in the viscoelastic properties could be ascribed to the localization of the large flexible loop, typical of Class I hydrophobins which appears free at the air interface for LB monolayers but not for the other samples. These findings should now serve future developments and applications of hydrophobin films beyond the archetypal monolayer.