A new and practical testing technique was developed for measuring the flow rate distribution between cells in a stack that did not contain any internal sensors. The flow rate distribution is obtained by measuring the hydrogen limiting current of each cell in the stack while a mixed gas of hydrogen and dimethyl ether is supplied to the anode and hydrogen to the cathode. In order to measure large flow rate deviations between cells, it is necessary to decrease the flow rate of the anode hydrogen and to sufficiently humidify the cells. The faster the increasing rate of the current, the more the apparent hydrogen limiting current increases than the theoretical electrochemical equivalent current. However, the relative flow rate deviations between cells can be obtained by a practical accuracy using the ratio of the apparent hydrogen limiting current. Humidification of the cell is indispensable for the measurement and a method using dry anode gas and humidified cathode gas is recommended. The preferred test conditions for measuring the flow rate distribution between cells in a PEFC stack are proposed. (C) 2011 Elsevier B.V. All rights reserved.