Wet glass bead powders with solid-to-liquid volume ratios between 2 and 3 were extruded through cylindrical dies by means of a ram extruder. The vertical stress exerted by the ram and the wall normal stress above the die were recorded. A continuum mechanical model was developed to calculate stress fields in the extruder barrel as a function of the load superimposed by the ram. The model predicts that the vertical stress, the wall normal stress and the wall shear stress decrease exponentially above the die entry region. A sudden increase in wall normal and wall shear stresses is observed where the powder in the die vicinity starts to be vertically accelerated. The stresses then decrease to zero from this point to the die which is in agreement with experimental observations. Calculated wall normal stresses are consistent with measured values. (C) 2011 Elsevier B.V. All rights reserved.