Blends of low-density polyethylene (LDPE) and polylactide (PLA) were prepared by melt coextrusion The plastic behavior of the LDPE/PLA blends was investigated at room temperature under uniaxial tension by means of a video-controlled system The constitutive behavior was analyzed in terms of the variations of true stress vs true strain at constant true strain rate With increasing concentrations of PLA, the blend show (i) higher Young's modulus, (ii) stiffer viscoelastic response, (iii) increase of elastic limit stress, and (iv) earlier fracture Particular attention was paid to the evolution of the volume strain with the applied strain While dilatation begins very lately for the neat LDPE, the LDPE/PLA blends show increasing deformation damage as the PLA content is increased Scanning electron microscopy of deformed specimens shows that cavitation occurs preferentially at the poles of the PLA particles whose adhesion to the LDPE matrix seems very weak despite the partial grafting of polyethylene chains with maleic anhydride POLYM ENG SCI, 51 117-125 2011 (C) 2010 Society of Plastics Engineers