Linear low density polyethylene (LLDPE) can suffer from melt extrusion defects including sharkskin, cyclic melt fracture, and gross melt fracture during processing. Arborescent polymers are dendritic macromolecules with characteristics, such as a compact structure and a rigid spherical topology, making them potentially useful as polymer processing additives (PPA) to alleviate melt extrusion defects. Arborescent polystyrene-graft-polyisoprene copolymer samples were synthesized from polystyrene substrates of linear and branched architectures functionalized with acetyl groups, and coupled with polyisoprene macroanions. A linear polyisoprene sample was also investigated for comparison. The polymers were hydrosilylated with (tridecafluoro-1,1,2,2-tetrahydrooctyl)dimethylsilane on 17-52% of the isoprene units and blended with LLDPE at 0.1 and 0.5% w/w to evaluate their performance as PPA by extrusion at different shear rates. All the samples led to some degree of improvement in the extrusion of LLDPE, albeit the performance of the branched additives was inferior to a commercial fluoroelastomer PPA. The lower molecular weight and more compact (GO or comb-branched) PPA generally performed better than those with a high molecular weight. Several PPA samples induced the early onset of cyclic melt fracture but glossy, defect-free surfaces were obtained at higher shear rates. This suggests that a minimum shear rate is required for these additives to coat the extrusion die under the experimental conditions used. (C) 2010 Elsevier Ltd. All rights reserved.