Journal of the American Chemical Society, Vol.132, No.7, 2385-2392, 2010
Crystal Structure, Diffusion Path, and Oxygen Permeability of a Pr2NiO4-Based Mixed Conductor (Pr0.9La0.1)(2)(Ni0.74Cu0.21Ga0.05)O4+delta
We have investigated in situ the crystal structure, oxygen diffusion path, oxygen permeation rate, and electrical conductivity of a doped praseodymium nickel oxide, Pr2NiO4-based mixed conductor, (Pr0.9La0.1)(2)(Ni0.74Cu0.21Ga0.05)O4+delta (PLNCG) in air between 27 degrees C and 1015 6 degrees C The PLNCG has a tetragonal I4/mmm K2NiF4-type structure which consists of a (Pr0.9La0.1)(Ni0.74Cu0.21Ga0.05)O-3 perovskite unit and a (Pr0.9La0.1)O rock salt unit in the whole temperature range Both experimental and theoretical electron density maps indicated two-dimensional networks of (Ni0.74Cu0.2Ga0.05)-O covalent bonds in PLNCG Highest occupied molecular orbitals (HOMO) in PLNCG demonstrate that the electron-hole conduction occurs via Ni and Cu atoms in the (Ni0.74Cu0.21Ga0.05)-O layer The bulk oxygen permeation rate was high (137 mu mol cm(-2) min(-1) at 1000 degrees C), and its activation energy was low (51 kJ mol(-1) at 950 degrees C) The Rietveld method, maximum-entropy method (MEM), and MEM-based pattern fitting analyses of neutron and synchrotron diffraction data indicate a large anisotropic thermal motion of the apical O2 oxygen at the 4e site (0, 0, z, z approximate to 0 2) in the (Pr0.9La0.1)(Ni0.74Cu0.21Ga0.05)O-3 perovskite unit Neutron and synchrotron diffraction data and theoretical structural optimization show the interstitial oxygen (O3) atom at (x, 0, z) (x approximate to 0.6 and z approximate to 0.2). The nuclear density analysis indicates that the bulk oxide-ion diffusion, which is responsible for the high oxygen permeation rate, occurs through the interstitial O3 and anisotropic apical O2 sites The nuclear density at the bottleneck on the oxygen diffusion path increases with temperature and with the oxygen permeation rate The activation energy from the nuclear density at the bottleneck decreases with temperature, which is consistent with the decrease of the activation energy from oxygen permeation rate The extremely low activation energy (12 kJ mol(-1) at 900 degrees C) from the nuclear density at the bottleneck indicates possible higher bulk oxygen permeation rates in quality single crystals and epitaxial thin films.