The paper discusses experimental features relevant to the synthesis of carbon-supported Pt3Sn nanosized particles by impregnation-reduction of the salt precursors in carbon. Colloidal techniques are proposed as the most suitable ones for obtaining carbon-supported nanosized Pt3Sn particles. In most cases, the electrocatalysts obtained have a wide range of Pt and Sn phases, including bimetallic ones. The synthesis of similar materials by impregnating readily available precursors such as SnCl2 and H2PtCl6 yields Pt-enriched catalyst precursors. In order to obtain electrocatalysts with the desired Pt:Sn=3 atomic stoichiometry, it is necessary to eliminate chloride ions prior to thermal treatments. Microscopy characterization and thermal stability studies of the fresh and treated bimetallic materials reveal that if such ions are present, Sn is eliminated as volatile SnClx species at around 120-130 degrees C. Chloride elimination is achieved by ageing the catalyst precursor in water to ensure the complete hydrolysis of the SnCl2 precursor. This treatment should be performed once SnCl2 has been deposited on the carbon to avoid the formation of large Sn-oxide aggregates. A further thermal treatment in hydrogen results in the formation of the desired Pt3Sn intermetallic phase. The performance of the Pt3Sn/C samples in the CO and ethanol electrooxidation reaction has been studied by means of electrochemical techniques. The electrocatalysts prepared by the impregnation-reduction approach match the performance of the state-of-the-art Pt3Sn samples prepared by colloidal techniques. (C) 2010 Elsevier B.V. All rights reserved.