The application range and validity of two new NMR sequences (hereafter called sequence 1 and sequence 2) for the study of water-in-oil emulsions (w/o) has been assessed using model emulsions and comparison with results obtained by a commercial apparatus (Turbiscan). These new NMR sequences allow to determine the brine profile i.e. the vertical variations of the dispersed phase content (brine) in the NMR tube. Measuring these parameters as a function of time allows to monitor the separation (sedimentation and coalescence rate) between oil and water. The results obtained on model water-in-oil emulsions with both NMR sequences are consistent and meaningful for both stable and coalescing emulsions and are similar, even if not strictly identical, to the ones obtained with the Turbiscan. It also appears that the second NMR sequence is faster (30 s to obtain a profile compared with 3 min for the 1st one in the conditions used in this article) and has a broader application range. Indeed, for these two methods, the oil phase must have a viscosity higher or equal than values which is around 5 mPa s for the sequence 2 and 20-25 mPa s for the method 1. (C) 2011 Elsevier Inc. All rights reserved.