The phenomenon of temperature gradient bifurcation in a porous medium is analyzed by studying the convective heat transfer process within a channel filled with a porous medium, with internal heat generation. A local thermal non-equilibrium (LTNE) model is used to represent the energy transport within the porous medium. Exact solutions are derived for both the fluid and solid temperature distributions for two primary approaches (Models A and B) for the constant wall heat flux boundary condition. The Nusselt number for the fluid at the channel wall is also obtained. The effects of the pertinent parameters such as fluid and solid internal heat generations. Blot number and fluid to solid thermal conductivity ratio are discussed. It is shown that the internal heat generation in the solid phase is significant for the heat transfer characteristics. The validity of the one equation model is investigated by comparing the Nusselt number obtained from the LTNE model with that from the local thermal equilibrium (LTE) model. The results demonstrate the importance of utilizing the LTNE model in the present study. The phenomenon of temperature gradient bifurcation for the fluid and solid phases at the wall for Model A is established and demonstrated. In addition, the temperature distributions for Models A and B are compared. A numerical study for the constant temperature boundary condition was also carried out. It was established that the phenomenon of temperature gradient bifurcation for the fluid and solid phases for the constant temperature boundary condition can occur over a given axial region. (C) 2010 Elsevier Ltd. All rights reserved.