Droplet wetting on two parallel filaments may assume a barrel-shaped morphology or a liquid bridge depending upon the filament diameter and spacing, droplet volume, and contact angle. This paper is aimed to examine the dependency of droplet wetting length upon the above parameters. In the process, morphology of either a barrel-shaped droplet or a liquid bridge sitting on two parallel filaments is determined numerically by using surface finite element method (SFEM). Variation of wetting length with contact angle is examined at varying droplet volume, filament spacing, and droplet morphology. It is found that the droplet wetting length increases with decreasing filament spacing ratio as well as contact angle while it also increases with the growth of droplet volume. The dependency of wetting length upon contact angle behaves sensitive to filament spacing in the case of stable liquid bridges, while it exhibits nearly constant sensitivity to the contact angle in the case of barrel-shaped droplets. The quantitative relations yielded in this study can be considered as characteristic curves applicable for a variety of droplet-on-filament systems, particularly useful to wetting property characterization of filaments, micro liquid delivery, biological cell manipulation, etc. (C) 2010 Elsevier B. V. All rights reserved.