Ore transportation is one of the important unit operations in a mineral industry. In this study, three raw rubber compounds are prepared in three different blend ratios, and four types of raw rubber samples of pure NR with silica reinforced has been collected from the different tire retreading industries. Blend properties largely depend on the blend ratio and on the blending technique. The improvement in the physical properties such as cure characteristics, mechanical characterization, cross-link density, FTIR, thermal characterization SEM studies, and dynamic mechanical analysis has been studied in those samples. It has been found that retread rubber made with 80 phr XNBR and 20 phr NR has given the better results when compared with the other samples against all the characterization done. It is also seen that rubber made by the researchers are very good in tough, rigid and these are extremely able to withstand for using as a retread rubber for 35T dump trucks tire when compared with the retread rubber made by the tire retreading industries for different mines in India. POLYM. ENG. SCI., 48:2410-2417, 2008. (C) 2008 Society of Plastics Engineers