Multi-walled carbon nanotubes (MWNTs) were high-energy milled for 2 h in texanol after a polycarboxylic acid polymeric dispersant had been added in order to enhance the dispersion. The degree of MWNT dispersion was significantly enhanced by high-energy milling compared to the intact sample, which increased the density of surface-exposed MWNTs with a screen-printed paste. However, the emission properties of high-energy milled MWNTs did not show such a high emission current density relative to their increased surface-exposed density. Further investigation using Raman spectroscopy and X-ray diffraction evidenced the milling-induced MWNT damage, which explained the relatively lower emission current density of high-energy milled MWNTs. (C) 2008 Elsevier B.V. All rights reserved.