In this article, molecular orientation of crystalline and amorphous phases of both linear low-density polyethylene (LLDPE) and isotactic polypropylene (iPP) and epitaxy in the LLDPE/iPP blends prepared via dynamic packing injection molding have been investigated with the aid of polarized Fourier transform infrared (FTIR) spectroscopy and two-dimensional X-ray scattering (2D-WAXS). In LLDPE-rich blends, LLDPE was oriented along the shear flow direction, and iPP kept very low orientation. No epitaxial growth between LLDPE and iPP was observed. However, for the blends with LLDPE content less than 50 wt %, where iPP was the matrix and LLDPE formed the droplets, iPP was highly oriented along shear flow direction and LLDPE epitaxially grew onto iPP. The contact planes were (100)(LLEDPE) and (010)(ipp) and LLDPE molecules were about 50 degrees apart from the shear direction. The epitaxy fraction in LLDPE/iPP blends could be tentatively calculated from the values of orientation function of the LLDPE crystalline a-axis (f(a)) and that of crystalline b-axis (f(b)). Both tensile strength and tensile modulus decreased with the increase of LLDPE composition, indicating they were composition dependent, though shear-induced orientation and epitaxial crystallization might play some role. The impact strength of the blend samples reached a plateau in the LLDPE composition range of 20-50%, due to the contribution of orientation and epitaxy.