The filtration Of SiO2, Al2O3 and Fe2O3 particles with average sizes of 4 and 40 mu m using a fluidized bed filter at 40 and 300 degrees C was studied. The collection mechanisms, interparticle forces and bounce-off effect between filtered particles and collectors were analyzed to determine their effect on particle filtration. Experimental results showed that the collection efficiency of 4 mu m SiO2 and Al2O3 particles exceeded that of 40 mu m particles. Contrarily, the 40 mu m Fe2O3 Particles were collected more efficiently than the 4 mu m particles, because of the differences between the microstructures of SiO2, Al2O3, and Fe2O3 particles. The interaction between the particles affected the removal of mixed SiO2, Al2O3 and Fe2O3. The particle size distribution (PSD) of the particles in the exit was governed by the operating temperature, the original size of the filtered particles. the interparticle force and the hardness of the particles and the collectors. The smallest particles were not those most easily elutriated from the fluidized bed filter because they agglomerated with each other or with large particles. The van der Waal's force dominated the forces between 4 and 40 mu m particles. The main collection mechanism for 4 and 40 mu m particles was direct interception. The effect of impaction increased with particle size above 40 mu m. The strong impaction and bounce-off effect reduced the collection efficiency of 40 mu m SiO2 and Al2O3 particles. However, the strong interparticle force between Fe2O3 particles and collectors contributed to the high collection efficiency of the Fe2O3 particles. (C) 2009 Elsevier B.V. All rights reserved.