In this study, the possibility of using a biodegradable grade of thermoplastic poly(ethylene-co-vinyl alcohol) with high (71 mol %) vinyl alcohol (EVOH-29), as a carrier to incorporate the renewable and biodegradable component amylopectin (AP) into poly(lactic acid) (PLA) through melt blending, was investigated. The effect of using a plasticizer/compatibilizer (glycerol) in the blend systems was also investigated. In a first step, the EVOH/AP blends were produced and thereafter, in a second step, these were mixed with PLA. In this first study, the blend morphology was investigated using optical microscopy, scanning electron microscopy and Raman imaging spectroscopy and the thermal properties were measured by differential scanning calorimetry. Despite the fact that EVOH and AP are both highly polar, their blends were immiscible. Still, the blends exhibited an excellent phase dispersion on a micron level, which was enhanced further by the addition of glycerol. A good phase dispersion was finally observed by incorporation of the latter blends in the PLA matrix, suggesting that the proposed blending route can be successfully applied for these systems. Finally, the Differential scanning calorimetry (DSC) data showed that the melting point of EVOH dropped in the EVOH/AP blends, but the properties of the PLA phase was still relatively unaffected as a result of blending with the above components. (C) 2009 Wiley Periodicals, Inc. J Appl Polym Sci 115: 1315-1324, 2010