This paper explores the two-phase cooling performance of a hybrid cooling scheme in which a linear array of micro-jets deposits liquid gradually along each channel of a micro-channel heat sink. The study also examines the benefits of utilizing differently sized jets along the micro-channel. Three micro-jet patterns, decreasing-jet-size (relative to center of channel), equal-jet-size and increasing-jet-size, were tested using HFE 7100 as working fluid. It is shown feeding subcooled coolant into the micro-channel in a gradual manner greatly reduces vapor growth along the micro-channel. Void fraction increased between jets but decreased sharply beneath each jet, creating a repeated pattern of growth followed by coalesce, and netting only a mild overall increase in void fraction along the flow direction with predominantly liquid flow at outlet. Unlike most flow boiling situations, where pressure drop increases with increasing heat flux, pressure drop in the hybrid configurations actually decreased and reached a minimum just before CHF. This behavior is closely related to the low void fraction and predominantly liquid flow. Pressure drop in the two-phase region is highest for the equal-jet-size pattern, followed by the decreasing-jet-size and increasing-jet-size patterns, respectively. Low void fraction increased the effectiveness of the hybrid cooling schemes in utilizing bulk liquid subcooling and therefore helped achieve high CHF values. The decreasing-jet-size pattern, which had the highest outlet subcooling, achieved the highest CHF. A single correlation was constructed for the three jet patterns, which relates the two-phase heat transfer coefficient to heat flux and wall superheat. (C) 2009 Elsevier Ltd. All rights reserved.