This paper describes a label-free detection system for DNA strands based on gold electrodes and impedance measurements. A single-stranded 18 mer oligonucleotide (ssDNA) was immobilised via a thiol linker on gold film electrodes and served as probe DNA. Residual binding places were filled with mercaptobutanol. The sensor surface clearly distinguished between complementary and non-complementary target ssDNA. Additionally, detection of single base pair mismatches was possible. The electrode was impedimetrically characterised in the presence of the redox system ferri/ferrocyanide before and after DNA hybridisation. Impedance analysis showed that the charge transfer resistance. R, was increasing after DNA duplex formation, whereas the capacitive properties remain rather unaltered. The relative change of R-ct was used as sensor parameter. Concentrations in the nanomolar range have been detected by the system. The sensor was reusable because a denaturation protocol allowed effective double strand dissociation without changing the surface properties of the electrode substantially. The time for DNA detection have been reduced to about 15 min including regeneration. The sensor signal was amplified by about 20% after binding of a negatively charged molecule to the formed DNA duplex. The sensor was also capable of sensing longer target ssDNA strands as shown with 25 mer and 37 mer oligonucleotides. (c) 2009 Elsevier Ltd. All rights reserved.