Combustion and Flame, Vol.156, No.2, 505-521, 2009
Modeling of autoignition and NO sensitization for the oxidation of IC engine surrogate fuels
This paper presents an approach for modeling with one single kinetic mechanism the chemistry of the autoignition and combustion processes inside an internal combustion engine, as well as the chemical kinetics governing the postoxidation of unburned hydrocarbons in engine exhaust gases. Therefore a new kinetic model was developed, valid over a wide range of temperatures including the negative temperature coefficient regime. The model simulates the autoignition and the oxidation of engine surrogate fuels composed of n-heptane, iso-octane, and toluene, which are sensitized by the presence of nitric oxides. The new model was obtained from previously published mechanisms for the oxidation of alkanes and toluene where the coupling reactions describing interactions between hydrocarbons and NOx were added. The mechanism was validated against a wide range of experimental data obtained in jet-stirred reactors, rapid compression machines, shock tubes, and homogeneous charge compression ignition engines. Flow rate and sensitivity analysis were performed in order to explain the low temperature chemical kinetics, especially the impact of NOx on hydrocarbon oxidation. (c) 2008 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
Keywords:NO sensitization;Oxidation;Autoignition;Modeling;Primary reference fuel;Toluene;Jet-stirred reactor;HCCI engine