The recent reported pathway using oxygen and formic acid at ambient conditions has been utilized to generate hydrogen peroxide in situ for the degradation of phenol. An alumina supported palladium catalyst prepared via impregnation was used for this purpose. Almost full destruction of phenol was carried out within 6 h corresponding to the termination of 100 mM formic acid at the same time. In addition, a significant mineralization (60%) was attained. A simulated conventional Fenton process (CFP) using continuous addition of 300 ppm H2O2 displayed maximum 48% mineralization. Study of different doses of formic acid showed that decreasing the initial concentration of formic acid caused faster destruction of phenol and its toxic intermediates. The catalytic in situ generation of hydrogen peroxide system demonstrated interesting ability to oxidize phenol without the addition of Fenton's catalyst (ferrous ion). Lower Pd content catalysts (Pd1/Al and Pd0.5/Al) despite of producing higher hydrogen peroxide amount for bulk purposes, did not reach the same efficiency as the Pd5/Al catalyst in phenol degradation. The later catalyst showed a remarkable repeatability so that more than 90% phenol degradation along with 57% mineralization was attained by the used catalyst after twice recovery. Higher temperature (45 degrees C) gave rise to faster degradation of phenol resulting to almost the same mineralization degree as obtained at ambient temperature. Meanwhile, Pd leaching studied by atomic adsorption proved excellent stability of the catalysts. (C) 2009 Elsevier B.V. All rights reserved.