CFD simulations of trickle-bed reactors are presented with radial spreading of the liquid due to mechanical and capillary dispersion. Simulations are performed with various particle sizes and the significance of the dispersion mechanisms at the industrially relevant particle size range is analyzed. The effect of the bed porosity distribution and particle size to the simulation results is also discussed. The choice of the radial porosity profile is found to have a significant impact to the simulation results, especially when the Column to particle diameter ratio, D/d(p), is small. in which case the wall flow is important. The dependence of the standard deviation of porosity on the sample size is determined experimentally. Introducing just random variation of porosity to the model is found to describe inadequately the dispersive flow behavior. The presented hydrodynamic model with proper capillary and mechanical dispersion terms succeeds in capturing the features of the two independent physical phenomena. Separate models are presented for each dispersion mechanisms and it is shown that they both can have a significant contribution to the overall dispersion of liquid flowing through a packed bed. The hydrodynamic model is validated against the experimental dispersion profiles from Herskowitz and Smith [1978. Liquid distribution in trickle-bed reactors. A.I.Ch.E Journal 24, 739-454], Boyer et al. [2005. Study of liquid spreading from a point source in trickle-bed via gamma-ray tomography and CFD Simulation. Chemical Engineering Science 60. 6279-6288] and Ravindra et al. [ 1997. Liquid flow texture in trickle-bed reactors: an experimental Study. industrial & Engineering Chemistry Research, 36, 5133-5145]. The extent of liquid dispersion predicted by the presented hydrodynamic model is in excellent agreement with the experiments. (C) 2008 Elsevier Ltd. All rights reserved.