Electrophoresis, Vol.29, No.11, 2348-2355, 2008
Capillary electrophoresis chemiluminescent detection system equipped with a two-step postcolumn flow interface for detection of some enkephalin-related peptides labeled with acridinium ester
Despite its low equipment cost and simple design, as one of the sensitive detectors for CE, the chemiluminescence (CL) detector was less developed compared to the detectors of MS and LIF. The main reasons were the limitation of CL reagents, the repeatability problems and the relatively low sensitivity compared to LIF. In this paper, a highly sensitive CE-CL detection system was developed for detection of some enkephalin-related peptides labeled with acridinium ester. A new detection interface was designed for CE with CL detection of acridinium ester and its labeled analytes. The interface included two sections: one was used to acidify the capillary oufflow so that the corresponding acridinium pseudo-base form can be changed into acridinium ester form by adding excess acid to the system; the other was designed to provide a suitable solution to produce the CL from acridinium ester. The effect factors, such as pH, the concentration of reaction reagents and the flow rates of the reagents, were investigated. The results showed that acridinium ester had similar CL properties in this interface when pH values of CE BGE were changed from 2.0 to 10.8. The interface was used to detect acridinium ester and three acridinium ester-labeled enkephalinrelated peptides, the corresponding LODs were found to be in the attomole range. This CL detection system proved to be of high sensitivity, good repeatability, and relatively low cost.