Gas-phase photocatalytic oxidation (PCO) of nitric oxide (NO) with immobilized TiO2 films was studied in this paper. The immobilized TiO2 films were synthesized by hydrothermal method. The characterization for the physicochemical properties of catalysts prepared under different hydrothermal conditions were carried out by X-ray diffraction analysis (XRD), transmission electron microscopy (TEM), high resolution-transmission electron microscopy (HR-TEM), Brunauer-Emmett-Teller measurements (BET) and scanning electron micrograph (SEM). It was found that the PCO efficiency of the catalyst was mainly depended on the hydrothermal conditions. The optimal values of hydrothermal temperature and hydrothermal time were 200 degrees C and 24 h, respectively. Furthermore, it was also known that the photocatalytic efficiency would decrease remarkably when the calcination temperature was over than 450 degrees C. Under the optimal conditions (hydrothermal condition: 200 degrees C for 24 h; calcination temperature: 450 degrees C), the photocatalytic efficiency of catalyst could reach 60% higher than that of Degussa P25. (C) 2007 Elsevier B.V. All rights reserved.