Coal-based granular activated carbon (GAC) is saturated with trichloroethylene (TCE) by passing air through a fix bed adsorber. In surfactant-enhanced carbon regeneration, an aqueous solution of anionic surfactant, sodium dodecyl sulfate (SDS), is passed through the bed to induce desorption of TCE. More than 95% of the sorbed TCE was removed in the desorption operation with a 0.1 M SDS solution at a superficial flow rate of 1 cm/min. The desorption rate of TCE from pores of GAC is limited by pore diffusion and not significantly affected by either the concentration of SDS in the regenerant ( when well above the critical micelle concentration) or its flow rate. From the breakthrough curve of a subsequent adsorption cycle without a flushing step following the desorption, only 7% of the virgin carbon effective adsorption capacity is observed for the regenerated carbon. With a water flushing step following the regeneration step, the effective adsorption capacity is significantly improved to about 15% of that of virgin carbon. Increased temperature of the flushing water also enhances the effective adsorption capacity of the regenerated GAC. Separate batch adsorption-desorption isotherms of SDS on GAC support the enhanced desorption of SDS at elevated temperatures. The drastic reduction in the effective adsorption capacity of regenerated GAC results from the residual SDS remaining in the pores of GAC as confirmed by thermal gravimetric analysis. Both the regeneration and water flush steps are rate limited under conditionsused here.