Perovskite oxide La0.6Sr0.4Co0.2Fe0.8O3-delta (LSCF6428), a wonderful electronic-ionic conductor could be used as cathode of solid oxide fuel cell (SOFC). Graded cathode with coarse layer and fine layer, could improve the diffusion rate and electrochemical reaction activity of oxidant. The fabrication and properties of graded LSCF6428 cathode were discussed in this paper. First, pure perovskite LSCF6428 powders were prepared by citrate-EDTA method (CEM), citrate method (CM) and solid phase synthesis (SPS). The powders with higher specific surface area and smaller grain size are easier to be sintered and densified. Single LSCF6428 cathode with thickness of 30 mu m was prepared by SPS powders, the porosity of cathode was high about 30% and pore size was about 5 mu m. Graded LSCF6428 cathode including 30 gm outer layer and 10 mu m inner layer was prepared by SPS and CM powders, respectively. Clear double-layer cathode was observed by SEM, which combined tightly and transited gradually. Porosity of outer layer is high about 30% and pore size is about 1-5 mu m; inner layer is finer and pore size is about 0.2-1 mu m. Based on the above research, 300 mu m yttria stabilized zirconia (YSZ) electrolyte supported cell with single LSCF6428 cathode and double-layer LSCF6428 cathode were prepared, and the properties of two type cells were tested in H-2. Power density of graded cell is 197 mW cm(-2) at 950 degrees C, and improved about 46% comparing that of single layer LSCF6428 cell (135 mW cm(-2)). (C) 2007 Elsevier B.V. All rights reserved.