Capillary electrophoresis (CE) is a promising technique for assessment of free bilirubin and its interaction with albumin, as it requires only a small sample volume and provides a rapid and efficient separation of free bilirubin from its albumin-bound complex in a one-phase system. In order to maintain the equilibrium without dissociation of bilirubin from the albumin/bilirubin complex as in real clinical conditions, the coupling of CE with frontal analysis (FA) was investigated. A very large sample plug was introduced hydrodynamically into the capillary (36 cm length, 50 mu m inner diameter) at 15 psi.s to develop the frontal conditions during CE separation. The working conditions for CE/FA separation of bilirubin and albumin were optimized as follows: +20 kV; running buffer, 10 mmol/L phosphate and 1 mmol/L ethylenediaminetetraacetic acid (EDTA), pH 7.4. The working range for bilirubin was found to vary from 5 to 206 mu mol/L; precision with relative standard deviation (RSD) <2.0% for n = 3 and detection limit (signal to noise, S/N = 2) was 2 mu mol/L. The residual binding capacity of a simulated cord blood serum for bilirubin was 26 mg/100 mL at pH 7.4. Bilirubin was shown to be displaced from albumin when aspirin was added. The free bilirubin concentration was found to increase to clinical significant concentrations from 11.9 to 21.1% when increasing aspirin was added in the range of 5-50 mg/100 mL, respectively. Thus, the investigation of aspirin displacement of bilirubin from albumin is clinically important and the CE/FA method is a suitable procedure for this purpose.