Phase separation into controllable patterned microstructures was observed for Bombyx mori silkworm silk and poly(ethylene oxide) (PEO) (900 000 g/mol) blends cast from solution. The evolution of the microstructures with increasing PEO volume fraction is strikingly similar to the progression of phases and microstructures observed with surfactants. The chemically patterned materials obtained provide engineerable biomaterial Surfaces with predictable microscale features which can be used to create topographically patterned or chemically functionalized biomaterials. Solution blending was used to incorporate water-soluble PEO into silk to enhance elasticity and hydrophilicity. The sizes of the globule fibroin phase ranged from 2.1 +/- 0.5 to 18.2 +/- 2.1 mum depending on the ratio of silk/PEO. Optical microscopy and S EM analysis confirmed the micro-phase separation between PEO and silk. Surface properties were determined by XPS and contact angle. Methanol can be used to control the conformational transition of silk fibroin to the insoluble beta-sheet state. Subsequentially, the PEO can be easily extracted from the films with water to generate silk matrixes with definable porosity and enhanced surface roughness. These blend films formed from two biocompatible polymers provide potential new biomaterials for tissue engineering scaffolds.