In this paper two series of active carbons obtained at different flow rates of the activating agent, CO2, are characterized in order to establish the different mechanisms of pore development during the activation step. This study complements previous works on textural development during the different steps in the process of obtaining active carbons: coal oxidation, coal pyrolysis and char gasification. As the characteristics of the original and intermediate materials are of capital importance in the pore development of active carbons, the properties of the active carbons, precursor chars and coals were considered and analyzed together. Mercury porosimetry and helium picnometry were used to determine classical textural parameters as well as to perform a more detailed study of the pore volume generation during the different conditions of the activation step. Data obtained from the mercury porosimetry determinations was also employed for fractal determinations according to the methodologies proposed by Friesen and Mikula, Zhang and Li and the procedure of Neimark. Average surface fractal dimensions as well as fractal profiles and local surface fractal dimensions were calculated. The use of different flow rates during the activation step produces changes not only in the ordinary textural parameters but also in the fractal characteristics of the active carbons. Activation at higher flow rates leads to smoother fractal profiles and also to lower values of the average surface fractal dimensions of the active carbons. (c) 2007 Elsevier B.V All fights reserved.