The polarization behaviour of Armco iron in aqueous solutions of HCl with and without inhibitors has been studied by the potentiostatic method. At lower overvoltage values, the dissolution process is controlled by activation, while at higher overvoltage values, the dissolution process is controlled by diffusion. The inhibition of this metal corrosion in the aqueous solutions of HCl has been studied using four surfactants. Under the critical micelle concentration (CMC), the inhibition of these four surfactants is negligible. At a concentration higher than the CMC, the inhibiting action of tetradecyl trimethyl ammonium iodide (TTAI), tetradecyl trimethyl ammonium bromide (TTAB), hexadecyl trimethyl ammonium bromide (HTAB) and dodecyl trimethyl ammonium bromide (DTAB) increases rapidly. The process of inhibition was attributed to the formation of adsorbed film on the metal surface, that protects the metal against corrosive agents. Protection efficiency improved when the inhibitor concentration and the length of the alkyl chain were increased. The four quaternary ammonium salts tested were adsorbed on the Armco iron surface according to a Langmuir isotherm.