Activated carbon sorbents have the potential to be an effective means of mercury control in combustion systems. Reactions of activated carbons in flow systems with mercury and gas stream components were investigated to determine the types of chemical interactions that occur on the sorbent surface. The effects of carbon type, panicle size, temperature, and reactive gases were studied. Sorption kinetics and capacities for lignite- and bituminous-based carbons were compared with those for catalytic carbons at temperatures of 107 degrees C, 150 degrees C, and 163 degrees C. In the air and baseline gas studies, the catalytic carbons exhibited far better sorption than the lignite- and bituminous-derived carbons. With the catalytic carbons, the greater sorption kinetics and capacity in an air stream or baseline gas composition compared with nitrogen provides a clear demonstration that O-2 is required in the gas stream for higher reactivities and capacities. Thus, a catalytic chemisorption mechanism predominates for the sorption of mercury at these conditions. The reaction kinetics are inversely proportional to the temperature, indicating that a preliminary physisorption step with mercury associating with a surface site is rate-determining. In synthetic flue gas streams containing HCl (50 ppm), the sorption kinetics of the catalytic carbon are slightly inferior to those of lignite-based carbon. Thus, the reaction is dominated by a different interaction, where HCl reacts with mercury on the carbon surface and the oxidation sites on the catalytic carbon apparently have no advantage. Granular and fine-particle carbons gave similar results in flue gas streams.