The effect of different organoclays and mixing methods on the cure kinetics and properties of epoxy nanocomposites based on Epon828 and Epicure3046 was studied. The two kinds of organoclay used in this study, both based or natural montmorillonite but differing in intercalant chemistry, were 1.30E (Nanomer 1.30E-treated with a long-chain primary amine intercalant) and C.30B (Cloisite 30B-treated with a quaternary ammonium intercalant, less reactive with epoxy than the primary amine). The two mixing processes used to prepare the nanocomposites were (i) a room-temperature process, in which the clay and epoxy are mixed at room temperature, ant (ii) a high-temperature process, in which the clay and epoxy are mixed at 120 degrees C for 1 h by means of mechanical mixing. The nanocomposites were cured at room temperature and at high temperature. The quality of dispersion and intercalation/exfoliation were analyzed by scanning electron microscopy, transmission electron microscopy, and X-ray diffraction. The heat evolution of the epoxy resin formulation and its nanocomposite systems was measured using differential scanning calorimetry at different heating rates of 2.5, 5, 10, 15, and 20 degrees C min(-1). The cure kinetics of these systems was modeled by means of different approaches. Kissinger and isoconversional models were used to calculate the kinetics parameters while the Avrami model was utilized to compare the cure behavior of the epoxy systems. The cure kinetics and mechanical properties were found to be influenced by the presence of nanoclay, by the type of intercalant, and by the mixing method.