In developing his powder classification, Geldart [D. Geldart, Powder Technol. 7 (1973) 285.] employed fluidization data obtained only at ambient temperature and pressure and from beds fluidized only with air. Unfortunately, industrial applications of fluidized bed technology invariably are at elevated pressure and temperature and with fluidizing gas other than air. Geldart classification of powders does not apply at elevated pressure and temperature. There are ample evidences reported in the literature indicating that normally Geldart Group B powders at ambient conditions, such as polymer particles, can behave like a Group A powder under polymerization conditions at elevated pressure and moderate temperature with substantial emulsion-phase expansion, relatively small bubbles, smooth fluidization, and reduced gas bypassing [J.R. Grace, Can. J. Chem. Eng. 64 (1986) 353; I.D. Burdett, R.S. Elsinger, P. Cai, K.H. Lee, Gas-phase fluidization technology for production of polyolefins, in Fluidization X, Eds. M. Kwauk, J. Li, W.C. Yang, 2001, pp. 39-52; P.N. Rowe, P.U. Foscolo, A.C. Hoffmann, J.G. Yates, X-ray observation of gas fluidized beds under pressure, in Fluidization IV, Eds. D. Kunii, R. Toei, 1983, pp. 53-60]. Similar findings were also reported for Geldart Group B powders fluidized by supercritical carbon dioxide at elevated pressures [C. Vogt, R. Schreiber, J. Werther, G. Brunner, Fluidization at supercritical fluid conditions, in Fluidization X, Eds. M. Kwauk, J. Li, W.C. Yang, 200 1, pp. 117-124; C. Vogt, R. Schreiber, G. Brunner, J. Werther, Powder Technol. 158 (2005) 102; D. Liu, M. Kwauk, H. Li, Chem. Eng. Sci. 51 (1996) 4045; M. Poletto, P. Salatino, L. Massimilla, Chem. Eng. Sci. 48 (1993) 617; A. Marzocchella, P. Salatino, AIChE J. 46 (2000) 901]. The original Geldart's classification is modified and re-interpreted in this paper by plotting a dimensionless density against the Archimedes number. The new parameters allow powders with different properties fluidized at different pressures and temperatures with gases of different properties to be plotted in the same graph. The proposed modification successfully transforms the normally Geldart Group B particles at ambient conditions to Group A classification when fluidized at elevated pressure and temperature. The selection of these two parameters, the dimensionless density and the Archimedes number, for plotting is not arbitrary, however. The experimental and theoretical development is discussed. (c) 2006 Elsevier B.V. All rights reserved.