Acid mine drainage (AMD) has long been a significant environmental problem resulting from the microbial oxidation of iron pyrite in the presence of water and air, affording an acidic solution that contains toxic metal ions. The main objective of this study was to remove metal ions [Fe(II), Fe(III), Mn(II), Zn(II)] from AMD using lignite, a low-cost adsorbent. The lignite sorbent was utilized for the sorption of ferrous, ferric, manganese, zinc, and calcium ions in aqueous solutions. Studies were performed at different pH to find optimum pH. Equilibrium isotherms were determined to assess the maximum adsorption capacity of lignite for different metal ions. Sorption capacities were compared in single, binary, ternary, and multicomponent systems. The sorption data are correlated with Freundlich and Langmuir isotherms in each system. Both Freundlich and Langmuir isotherms fit the data reasonably well in terms of regression coefficients. Sorption studies were also performed at different temperatures to obtain the thermodynamic parameters of the process. The maximum lignite adsorption capacities at 25 degrees C were 34.22, 25.84, and 11.90 mg/g for Fe(II), Mn(II), and Fe(III), respectively. Adsorption of Fe2+ (24.70 mg/g at 10 degrees C and 46.46 mg/g at 40 degrees C) increased with increased temperature, while Mn2+ adsorption (28.11 mg/g at 10 degrees C and 7.70 mg/g at 40 degrees C) decreased with increased temperature. (c) 2006 Elsevier Inc. All rights reserved.