New regional (two-dimensional) seismic reflection data, published Deep-Sea Drilling Project-Ocean Drilling Program reports and, unpublished shallow-offshore well information characterize the Mesozoic-Cenozoic evolution of the western Iberian continental slope north of 38 degrees 45'N. Two distinct sectors bounded by first-order transfer faults exist between the Galicia Bank and the Nazare fault. The northernmost sector I is filled by Triassic-Aptian (pre-breakup) sequences, reaching more than 3.5 s two-way traveltime (TWTT) in thickness in distinct half grabens. Salt pillows, salt ridges, minibasins, and salt-detached overburden faults were generated during the Mesozoic and reactivated in the Cenozoic. Sector 2 shows Triassic-Jurassic units more than 2.0 s TWTT thick under, lying cast-tilting half grabens of Early Cretaceous age. Salt structures in this sector evolved into mature salt diapirs. Postbreakup units are up to 2.0 s TWTT thick in both sectors. The evolution of the study area replicates evolutionary settings that have previously been proposed for nonvolcanic passive margins. However, some distinct features are noted: (1) widespread Triassic-Berriasian units deposited over rotated tilt blocks represent the early rifting stage; (2) Early Cretaceous subbasins showing rift-climax units, most likely formed during the advanced rifting stage, are spatially constrained to an approximately 100-km (62-mi)-wide region stretched along the continental slope; and (3) listric blocks and their associated low-angle (deep) detachment faults, formed on the distal margin during the advanced rifting and transition to sea-floor spreading stages, show no developed rift-climax units above them. From the early rifting stage onward, Mesozoic faults and halokinetic structures induced local differences in the thickness and character of seismic facies. Cenozoic (Alpine) tectonism promoted the reactivation of older Mesozoic structures.