The optical properties of very thin gold films have been evaluated by Fresnel analysis, with optical boundary conditions pertaining to the surface plasmon resonance (SPR) at the gold-water interface. The experimental SPR characteristic was evaluated in the angular interrogation mode. Film morphology was characterized by high resolution transmission electron microscopy. The magnitude of the resonance, i.e., the SPR signal, sensitively depends on, and is affected by film thickness and morphology. A sharply defined thickness of 55 +/- 5 nm is required, to achieve optimum SPR excitation conditions, and instrumental sensitivity. With decreasing film thickness, below 40 nm, the resonance angle starts to shift to larger values. A substantial increase of the intrinsic resonance broadening parameter is observed below 70 nm, associated with an increasingly asymmetric SPR line shape. A similar effect occurs in the presence of a very thin chromium adhesion layer. Surface roughness and film thickness modulations determine the experimentally observed line broadening parameter. Instrumental noise levels largely depend on accuracy and quality at which the resonance angle can be determined. Substantial improvement and instrumental sub-pixel resolution is achievable by optimum fitting routines, accounting for drastic noise reduction and improved instrumental sensitivity, up to two orders of magnitude over the inherent geometric sensor pixel resolution. (c) 2005 Elsevier B.V All rights reserved.