ATRP of several methacrylates viz, methyl methacrylate (MMA), ethyl methacrylate (EMA), n-butyl methacrylate (nBMA), t-butyl methacrylate (tBMA), benzyl methacrylate (BzMA) and (N,N-dimethylamino)ethyl methacrylate (DMAEMA) has been studied in neat as well as aqueous (up to 12 vol% water) acetone at 35 degreesC using CuCl/bipyridine (bpy) catalyst and ethyl 2-bromoisobutyrate as the initiator. Addition of water significantly enhances the rate of polymerization without losing control. Unlike CuCl/bpy the CuBr/bpy catalyst gives poor control which is attributed to the lower solubility and consequent heterogeneity in the latter case. Of the other ligands used with the CuCl catalyst viz. o-phenanthroline (o-phen), 1,1,4,7,7-pentamethyldiethylenetriamine (PMDETA), 1,1,4,7,10,10-hexamethyltriethylenetetramine (HMTETA), Me6TREN only o-phen offers reasonably good control. The CuCl/bpy catalyst system has been used also in preparing some di- and tri-block copolymers with reasonably low polydispersity index (PDI) at ambient temperature (35degreesC) using aqueous acetone as the solvent. The following block copolymers have been prepared PMMA-tBMA, PMMA-b-tBMA-b-MMA, PMMA-DMAEMA, by this method. (C) 2004 Published by Elsevier Ltd.