The effect of confinement on the kinetics of the surface hydrolysis of polystyrene-block-poly(tert-butyl acrylate) (PSn-b-PtBA) thin films on oxidized silicon substrates in 3 M aqueous hydrochloric acid was systematically investigated. As shown by X-ray photoelectron spectroscopy (XPS) and contact angle measurements, a skin layer of acid-sensitive PtBA is present on the surface of PSn-b-PtBA. films, consistent with the lower surface tension of PtBA compared to that of PS. The thickness of the skin layer was determined by angle-dependent XPS as similar to 8 nm for PS690-b-PtBA(1210). Tapping mode atomic force microscopy showed an increasing surface coverage of swollen poly(acrylic acid)-rich globules with increasing hydrolysis time. Using ex situ Fourier transform infrared spectroscopy, the reaction kinetics was determined quantitatively as a function of temperature, polymer film thickness, thermal pretreatment of the films, and block copolymer composition. The initial stages of the hydrolysis can be described as a pseudo-first-order reaction under all conditions investigated. The corresponding rate constants were found to be 2 orders of magnitude lower than those reported for the hydrolysis of tert-butyl acetate in solution and depended linearly on the fraction of PtBA exposed at the surface. However, the polymer film thickness, thermal pretreatment of the films, block copolymer composition, and local composition did not affect the rate constants. The negative value of the activation entropy (Delta S-298(double dagger) = 103 J/mol K), determined according to the Arrhenius equation and transition state theory, indicates that the tightness of the transition state is more pronounced in the PSn-b-PtBA(m) film compared to reactions in solution. Thus, the spatial constraints due to the incorporation of the reactive ester groups in thin polymer films are responsible for the observed reduced reactivity.