Solid structure formation in the drying step for wet spinning of poly(1-oxotrimethylene) using as a solvent an aqueous solution of complex metal salts of calcium chloride/zinc chloride was studied. Because the degree of structural densification and the crystal structure both differ depending on the drying temperature, the drying temperature had a major effect on the drawing behavior and the strength achieved after drawing. With higher drying temperature, the denseness increased due to smaller voids in the dried undrawn fiber, while there was also a tendency toward higher strength with respect to the draw ratio. However, an excessively high drying temperature altered the crystal structure from a rough crystalline form to a dense crystalline form and reduced both the maximum draw ratio and strength. Mechanical cleavage of the molecular chains occurred between the ethylene groups and carbonyl groups of the main chains in the drawing step. This cleavage made it possible to suppress the inhibition of drawing due to entanglement of the molecular chains, thereby enabling superdrawing to afford a high performance fiber. (C) 2004 Wiley Periodicals, Inc.