This article aims at clarifying the possible design and operating conditions for silica gel-water adsorption refrigeration cycles driven by near-ambient temperature waste heat sources (between 45 and 75degreesC) with relatively small regenerating temperature lifts (15 to 45K). A two-stage silica gel-water advanced adsorption chiller is introduced and a simulation model of the chiller was developed to analyze the influence of operating and design conditions on the system performance (coefficient of performance, COP, and cooling capacity). It was hypothesized that the proposed chiller can be driven by low temperature waste heat at 55degreesC to produce effective cooling. Simulation results show that the operating conditions such its cycle time and hot and cooling water inlet temperature have an influential effect on cooling capacity and COP. COP is proportional to cycle time and heat transfer coefficient as well as inversely proportional to the cooling water inlet temperature, while there are optimum values of hot water temperature and silica gel weight for maximum COP. Cooling capacity mainly improves with the addition of silica gel weight and decreases as cooling water temperature increases. Simulation results also revealed that the system performance can be improved significantly by setting the design and operating conditions optimally.