Methods for preparation of carbon/silicalite-1 composite membranes have been developed. First, silicalite-1 membranes were prepared by in-situ hydrothermal synthesis on both porous alumina and metal disks. Preparation of the carbon/silicalite-1 composite membranes was accomplished by polymerizing furfuryl alcohol on the surface of the silicalite-1 membrane, followed by carbonizing the polymer layer in an inert atmosphere at 773 K. The pure silicalite-1 membrane showed no selectivity for single gases, indicating the presence of intercrystalline diffusion and viscous flow as the dominant transport mechanism. The carbon/zeolite composite membrane exhibited ideal selectivities for He/N-2, CO2/N-2, and N-2/CH4 of 11.99, 17.12, and 3.58 at room temperature. No permeation of n-butane and i-butane for the composite membrane was detected up to temperatures of 453 K, indicating that the pore size for the composite membrane was approximately 0.4 nm. By carefully oxidizing the carbon layer in air at 623 K, the pore size of the composite membrane was adjusted such that n-butane permeation could be detected. No permeation of i-butane was apparent, suggesting that the pore size of the composite membrane had been enlarged to approximately 0.5 nm. Further oxidation of the carbon layer produced a finite n-/i-C4H4 ideal selectivity, indicating that the pore size of the membrane was now larger than 0.55 nm. Therefore, selective oxidation of the carbon layer can be used to control the pore size of the composite membrane.