It has been shown that scission kinetics strongly affects the molecular weight distribution (MWD) of low-density polyethylene (ldPE) in a continuous stirred tank reactor (CSTR). The present paper focuses on the effects of different chemical scission mechanisms, linear and topological scission, as well as mechanical scission on MWD in batch and tubular reactors. In contrast to the CSTR, a batch reactor MWD does not show bimodalities or long tails. The tubular reactor was modeled as an industrially representative system with four initiator injection points and a proper 'cocktail' of different initiators. Calculated MWD was compared to one experimentally determined with SEC-MALLS for a commercial tubular product and fair agreement was found. Typically, these MWDs are broad, but not bimodal. Sensitivity studies were performed as to scission kinetics and the effect of chain transfer agent (CTA). Both batch and tubular reactor were observed to be less sensitive to scission kinetics than a CSTR. In addition, alternative CTA injection strategies (downstream positions) were tested. These showed interesting behavior leading to very broad and bimodal MWD. The model allows following the MWD broadening along the tube. We conclude that batch and tubular ldPE reactors lead to completely different MWD behavior than a CSTR and that it is possible to manipulate it to a great extent. (C) 2004 Elsevier Ltd. All rights reserved.