When polyelectrolyte chains are grafted to colloidal particles, the electric field between particles is affected by the charges of the chains. In some previous theoretical attempts, the charge density of the polyelectrolyte chains per unit length was considered constant, and its effect was accounted for by introducing an additional constant charge density into the unidimensional Poisson-Boltzmann equation, which was evaluated assuming that it is uniformly distributed in the polyelectrolyte volume of the brush. In this paper, a more detailed model is employed for the calculation of the electrical potential between two plates on which polyelectrolyte brushes are present. In this model, the polyelectrolyte chain is viewed as a rigid cylinder, on the surface of which charges are generated through the dissociation of ionizable sites and adsorption of the cations of the electrolyte. To each of the chains an atmosphere is attached which for simplicity is assumed cylindrical. In the brush region, the electrical potential is described by a two-dimensional Poisson-Boltzmann equation, while in the region free of polyelectrolyte chains by a unidimensional Poisson-Boltzmann equation. Such a model is physically suitable when the charges of the chains are sufficiently large for the repulsion they generate to ensure that the chains are fully extended. Such cases are quite frequent, because relatively low charges lead to an almost complete extension of the chains. In this paper, both the plate surface and the surface of the cylinders are considered charged. The effects of electrolyte concentration, pH, brush thickness and chain coverage density on the repulsion between plates are examined. (C) 2004 Elsevier Inc. All rights reserved.