Phase morphology of polymer blends PP/ COC, where PP is polypropylene and COC is a copolymer of ethene and norbornene, was characterized by means of scanning electron microscopy (SEM) and scanning transmission electron microscopy (STEM). PP/COC blends were prepared by injection molding and their morphology was studied for six different compositions (90/10, 80/20, 70/30, 60/ 40, 50/50, and 25/75 wt%). The intention was to improve PP properties by forming COC cocontinuous phase, which should impart to the PP matrix higher stiffness, yield stress, and barrier properties. Surprisingly enough, all studied blends were found to have fibrillar morphology. In the 90/10, 80/20, and 70/30 blends, the PP matrix contained fibers of COC, whose average diameter increased with increasing COC fraction. In the 60/40 blend, the COC component formed in the PP matrix both fibers and larger elongated entities with PP fibers inside. The 50/50 blend was formed by COC cocontinuous phase with PP fibers and PP cocontinuous phase with COC fibers. In the 25/75 blend, PP fibers were embedded in the COC matrix. In all blends, the fibers had an aspect ratio at least 20, were oriented in the injection direction, and acted as a reinforcing component, which was proven by stress-strain and creep measurements. According to the available literature, the fibrous morphology formed spontaneously in PP/COC is not common in polymer blends. (C) 2003 Wiley Periodicals, Inc.