화학공학소재연구정보센터
Journal of Vacuum Science & Technology B, Vol.21, No.4, 1344-1349, 2003
Etching characteristics of porous silica (k=1.9) in neutral loop discharge plasma
Etching characteristics of a porous silica material (ISM-1.5(TM) produced in ULVAC, Inc.) were investigated and compared with those of thermal oxide. The etch rate of porous silica in magnetic neutral loop discharge plasma was approximately two times higher than that of thermal SiO2 film when linear saturated perfluorocarbon compounds were used. This may be due to the low film density of the porous silica. However, in the case of C4F8 (octafluorocyclobutane) plasma, the etch rate ratio to SiO2 was about 1.45. When C4F6 (CF2=CFCF=CF2: hexafluorobutadiene) was used, the etch rate ratio was also very low (0.6). So, the etch rate strongly depended on the gas structure, whereas the SiO2 etch rate did not depend on the gas species and was almost constant. Through mass spectrometry and x-ray photoelectron spectroscopy measurements, it was deduced that the fluorocarbon polymer formed in the pore suppressed the etch rate of porous silica in C4F8 or C4F6 plasmas. (C) 2003 American Vacuum Society.