The mode of adsorption of bovine serum albumin (BSA) on porous polyethylene (PE) membrane was studied as a function of time and concentration, which may contribute to the surface coverage. An improved physical model for adsorption is initiated based on the results of the adsorptional and desorptional measurements, FTIR analysis, and AFM observations as well as streaming potential measurements. The results obtained indicate that the adsorptional mode depend on both time and concentration. It is shown that a critical concentration (about 1000 ppm here) exists in the adsorptional process. Below this concentration, the adsorption seems to be conducted in a normal side-on way but time elapse gives rise to greater conformational change than concentration increase; above this concentration, the aggregation of protein molecular plays a decisive role and the adsorption is in an aggregation way, which is similar to end-on, but a relative large gap between the adsorbed molecules exists due to aggregation. This conclusion is general and can be expected to apply in other globular protein-hydrophobic porous surface systems. (C) 2003 Elsevier Science (USA). All rights reserved.